药品信息:
--------------------------------------------------------------- 详细处方信息以本药内容附件PDF文件(201171422355528.pdf)的“原文Priscribing Information”为准 --------------------------------------------------------------- 部分中文開心吉处方资料(仅供参考)
商品名:PLEGISOL 1000ML/BAG
中文名稱:開心吉 輸注液
成分:NaCl 0.643%, MgCl2 0.3253%, KCl 0.1193%, CaCl2 0.0176%.
劑型:1000ml/bag
儲存條件:室溫,避免日曬
適應症:With ischemia and hypothermia induce cardiac arrest during open heart surgery.
PLEGISOL® Plegisol (Hospira’s Cardioplegic Solution) is a sterile, nonpyrogenic, essentially isotonic, formulation of electrolytes in water for injection. It is a “core solution” intended for use only after addition of sodium bicarbonate to adjust pH prior to administration. After buffering with sodium bicarbonate it is suitable for cardiac instillation (usually with hypothermia) to induce arrest during open heart surgery. Other agents may be added to the solution prior to instillation. (See INSTRUCTIONS FOR USE.)Each 100 mL of solution contains calcium chloride, dihydrate 17.6 mg, magnesium chloride, hexahydrate 325.3 mg, potassium chloride 119.3 mg and sodium chloride 643 mg in water for injection. May contain HCl or NaOH for pH adjustment. Electrolyte content per liter (not including ions for pH adjustment): Calcium (Ca++) 2.4 mEq; magnesium (Mg++) 32 mEq; potassium (K+) 16 mEq; sodium (Na+) 110 mEq; chloride (Cl‾) 160 mEq. Osmolar concentration, 304 mOsmol/liter (calc.); pH 3.8 (3.5 to 3.9) prior to sodium bicarbonate addition. It is required that 10 mL (840 mg) of 8.4% Sodium Bicarbonate Injection, USP (10 mEq each of sodium and bicarbonate) be added aseptically and thoroughly mixed with each 1000 mL of cardioplegic solution to adjust pH. Use 10 mL of Hospira List 4900, 8.4% Sodium Bicarbonate Injection, USP, to achieve the approximate pH of 7.8 when measured at room temperature. Use of any other Sodium Bicarbonate Injection may not achieve this pH due to the varying pH’s of Sodium Bicarbonate Injections. Due to its inherent instability with other components, sodium bicarbonate must be added just prior to administration. After this addition, the solution must be stored under refrigeration and be used within 24 hours. The buffered admixture contains the following electrolytes (per liter): Ca++ 2.4 mEq, Mg++ 32 mEq, K+ 16 mEq, Na+ 120 mEq, Cl‾ 160 mEq and bicarbonate (HCO3‾) 10 mEq; osmolar concentration, 324 mOsmol/liter (calc.); pH 7.8 (approx.). If other agents are added, these values may be altered. The solution contains no bacteriostat, or antimicrobial agent and is intended only for use (after adjusting pH with sodium bicarbonate) in a single operative procedure. When smaller amounts are required, the unused portion should be discarded. Plegisol with added sodium bicarbonate used as a coronary artery infusate induces cardiac arrest, combats ischemic ionic disturbances, buffers ischemic acidosis and protects energy sources for functional recovery after ischemia.
Plegisol (Calcium chloride/Magnesium chloride/Potassium chloride/Sodium Chloride INTRA-ARTERIAL) is indicated for the following:
Plegisol (Hospira’s Cardioplegic Solution) when suitably buffered in combination with ischemia and hypothermia is used to induce cardiac arrest during open heart surgery.
INDICATIONS AND USAGE Plegisol (Hospira’s Cardioplegic Solution) when suitably buffered in combination with ischemia and hypothermia is used to induce cardiac arrest during open heart surgery.
DOSAGE AND ADMINISTRATION The following information is suggested as a guide and is subject to variation according to the preference and experience of the surgeon.
It is required that 10 mL (840 mg) of 8.4% Sodium Bicarbonate Injection, USP (10 mEq each of sodium and bicarbonate) be added aseptically and thoroughly mixed with each 1000 mL of cardioplegic solution to adjust pH. Use 10 mL of Hospira List 4900, 8.4% Sodium Bicarbonate Injection, USP, to achieve the approximate pH of 7.8 when measured at room temperature. Use of any other Sodium Bicarbonate Injection may not achieve this pH due to the varying pH’s of Sodium Bicarbonate Injections. Due to its inherent instability with other components, sodium bicarbonate must be added just prior to administration. After this addition, the solution must be used within 24 hours. The solution should be cooled to 4°C prior to use.
Following institution of cardiopulmonary bypass at perfusate temperatures of 28° to 30°C, and after cross-clamping of the ascending aorta, the buffered solution is administered by rapid infusion into the aortic root. The initial rate of infusion may be 300 mL/m2/minute (about 540 mL/min in a 5’8”, 70 kg adult with 1.8 square meters of surface area) given for a period of two to four minutes. Concurrent external cooling (regional hypothermia of the pericardium) may be accomplished by instilling a refrigerated (4°C) physiologic solution such as Normosol®-R (balanced electrolyte replacement solution) or Ringer’s Injection, USP into the chest cavity.
Should myocardial electromechanical activity persist or recur, the solution may be reinfused at a rate of 300 mL/m2/min for a period of two minutes. Reinfusion of the solution may be repeated every 20 to 30 minutes or sooner if myocardial temperature rises above 15° to 20°C or returning cardiac activity is observed. The regional hypothermia solution around the heart also may be replenished continuously or periodically in order to maintain adequate hypothermia. Suction may be used to remove warmed infusates. An implanted thermistor probe may be used to monitor myocardial temperature.
The volumes of solution instilled into the aortic root may vary depending on the duration or type of open heart surgical procedure.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. (See PRECAUTIONS.)
INSTRUCTIONS FOR USE To Open Tear outer wrap at notch and remove solution container. If supplemental medication is desired, follow directions below before preparing for administration. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually.
To add 10 mL of 8.4% Sodium Bicarbonate Injection, USP, Hospira List 4900, and other supplemental medication, follow directions below before preparing for administration.
To Add Medication Prepare additive port. Using aseptic technique and an additive delivery needle of appropriate length, puncture resealable additive port at target area, inner diaphragm and inject. Withdraw needle after injecting medication. The additive port may be protected by covering with an additive cap. Mix container contents thoroughly.
Preparation for Administration (Use aseptic technique) Close flow control clamp of administration set. Remove cover from outlet port at bottom of container. Insert piercing pin of administration set into port with a twisting motion until the set is firmly seated. NOTE: See full directions on administration set carton. Suspend container from hanger. Squeeze and release drip chamber to establish proper fluid level in chamber. Attach aortic infusion device to set. Open flow control clamp to expel air from set and aortic infusion device. Close clamp. Position aortic infusion device to introduce solution into aortic root. Regulate rate of administration with flow control clamp.
HOW SUPPLIED Plegisol® (Hospira’s Cardioplegic Solution) is supplied (without sodium bicarbonate) in a single-dose 1000-mL flexible plastic container (List No. 7969).
WARNING: Do not use flexible container in series connections. Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. Protect from freezing. It is recommended that the product be stored at room temperature (25°C); however, brief exposure up to 40°C does not adversely affect the product.
--------------------------------------------------------------- 详细处方信息以本药内容附件PDF文件(201171422355528.pdf)的“原文Priscribing Information”为准 --------------------------------------------------------------- |